![]() ![]() ![]() MOTOROLA MCS2000 PICTURES AND INFORMATION. Motorola Moto C Mic Ways Solution: Yel - Pin #6 (Mic) NOTE : On some radios Pin #3 is a low level audio output (100-300mv) and will NOT work properly with the BayPac. Wiring Handbook Disclaimer: Astatic Does not assume the responsibility of any damage to either the microphone nor any radio that has been modified to the specifications within this manual. If the radio is operating in analogue mode, flat or de-emphasis would be programmed by CPS. To operate the node without a microphone plugged in, make an RJ45 mic plug shorting the PL line (PIN 3) to ground (PIN 4). ![]() The mic is responsible for sending your voice to the person on the other end of a phone call, recording sounds while making videos or simply using voice recording apps. Determine which pin on the radio’s mike socket performs which function (TX, RX, Audio, Ground) on the CB itself. There are no replacement parts, it's a throw away mic. Motorola used the same microphone pinout for a very long time. Updated: November 2002 Motorola Remote Speaker Microphones Enhance Communication Introducing Remote Speaker Microphones that offer Windporting, Noise-Canceling Acoustics and/or IP57 Submersibility features Motorola’s Remote Speaker Microphones (RSMs) are a vital two-way radio accessory solution for users who need to talk and listen without removing Here is a general schematic for building or adapting a base microphone to the AnyTone 578. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |